6-8" Lift Kit Stage 1 System 01-10 GM HD 2500 / 3500

THIS KIT USES OUR UNIQUE ONE PIECE SUB-FRAME DESIGN. NEXT WE ADD STRUT BAR SUPPORTS, REINFORCED UPPER CONTROL ARM DROP MOUNTS, AND A STEERING DROP DOWN W/ HEIM JOINTED SUPPORT LINKS.

THE CST SYSTEM WILL DROP DOWN THE FACTORY SUSPENSION A TRUE SIX INCHES, INSURING THAT FACTORY STEERING AND 4 WHEEL DRIVE CV ANGLES WILL REMAIN WITHIN FACTORY SPECS. THIS KIT DOES NOT INCREASE THE TRACK WIDTH AND WITH THE USE OF CST SHOCKS OVER ALL RIDE QUALITY WILL BE IMPROVED. 2009 UP MODELS ARE EQUIPPED WITH THE GM STABILITRAK SYSTEM, INSTALLATION OF THIS KIT WILL NOT AFFECT IT IN ANY WAY.

• PARTS COVERED IN A TWO-STAGE HIGH QUALITY GLOSS BLACK POWDER COAT FINISH.
• ABILITY TO BE PUT VEHICLE BACK TO STOCK.
• NEW CENTER-LINK THAT’S SUPPORTED WITH HEIM-JOINTS OFF OF THE SUB-FRAME TO REDUCE LATERAL MOVEMENT OF THE O.E. STEERING ARMS.
• NO MODIFICATIONS TO THE FRONT DIFF!
• FACTORY RIDE & HANDLING!

INSTALL NOTES:

• 5” MAX BACK-SPACING
• ADDITIONAL REAR LIFT REQUIRED FOR A LEVEL STANCE ON SOME VEHICLES AND WHEN SUSPENSION IS SET AT 8 INCHES.
• APPROVED FOR 2WD AND 4WD GM 1500HD!
• CST FRONT DRIVE-SHAFT REQUIRED FOR 4WD USE AT HIGHWAY SPEEDS (LISTED BELOW)
• TESTED & APPROVED FOR GM 3500 & 3500 DUALLY MODELS. MAY REQUIRE ADDITIONAL REAR PARTS, CHECK WITH YOUR LOCAL DEALER FOR DETAILS!

SUGGESTED WHEEL & TIRE SIZES

• 35” Tires on 9-10” wide wheels w/ 4 to 5 inches of back-spacing. (minor trimming required on some tires with 10” wide wheels)
• 37” Tires on 8-9” wide wheels w/ 4 to 5 inches of back-spacing and suspension set at 8 inches of lift w/ minor trimming..

PARTS INCLUDED:

• CSS-C3-6-B1 (x1) SUBFRAME
• CSS-C3-6-B2 (x1) TORSION DROPS, UCA MOUNTS, SWAY BAR DROP
• CSS-C3-6-B3 (x1) STRUT BARS, DIFF MOUNTS, CENTERLINK