The new BDS Suspension 5.5" suspension system for the 2015 Chevy Colorado / GMC Canyon is designed with a tried-and-true steering knuckle and crossmember technology. The system has passed FMVSS126 testing for stability control compliance. Heavy-duty fabricated crossmembers drop the lower control arms, perfectly matching the massive ductile cast iron extended steering knuckles to gain 5.5" of lift. The crossmembers utilize the factory alignment eccentrics and tie together with a full-width skid plate. The skid plate protects the relocated differential that has been lowered and positioned to work precisely with the included transfer case indexing ring, allowing for the factory front drive shaft to be used.

The factory front struts are relocated using upper strut extensions that do not require disassembly of the strut. Front bump stop extension and sway bar links are included as well as new Moog tie rod ends to properly set alignment without trimming the inner tie rods. In the rear, as simple block/u-bolt combination sets the new ride height so it is level with the front.

In place of the factory struts this system uses precision tuned FOX 2.5 remote reservoir coil-overs to achieve superior on and offroad performance. The included Fox 2.5 Coil-Overs can also be upgraded to the DSC (dual speed compression) adjuster equipped coil-overs (more info below) for the ability to perfectly fine tune the ride quality and handling of your Fox coil-overs.

• 5.5" Overall Lift
• Front Fox 2.5 Reservoir Coilover Shocks
• Rear Fox 2.0 Performance Series Shocks
• High Quality Black Powdercoat Finish
• Full Width Skid Plate for Ultimate Protection
• All Required Components Included
• High Clearance Front Crossmembers
• T-Case Index Kit to Allow use of Stock Driveshafts
• FMVSS No. 126 Compliant Stability Control
• NO Fine Print Lifetime Warranty

Important Kit Notes:

1. Inner fender trimming is required.
2. Minor welding is required.
3. Electronic assisted power steering system is sensitive to out of round, unbalanced, and more aggressive tread pattern tires. High speed steering wheel feedback can occur.
4. Actual ride height on C/O kits is closer to 6'' of lift.
5. Stock 17" & 18" wheels can not be reinstalled with the lift kit. Aftermarket 20" wheels with maximum of 5.25" Backspacing are recommended - certain wheel and tire combinations will require weld on steering stops, these are included in the kit. See end of inst. sheet for details on installation.
6. Will not fit ZR2 Models.
7. Will fit diesel models.

Recommended Wheel & Tire:

305/55r20 Tires w/ 20×9 (5.25 BS) Wheels
305/70r17 Tires on 17×9 (4.5 BS) Wheels
295/70r17 Tires on 17×8 (4.5 BS) Wheels